Installation and Maintenance Guide for IDI Suspension System mounted to Canon DST-1000A Rails
L240-1429 REV A Image Diagnostics, Inc.
Page
8
E. INSTALLATION
UNPACK
No special handling is required for unpacking this equipment at the site.
Conventional shipping materials are used.
Recycle or disposal of shipping material per local regulations
INSTALL DST-1000A CEILING RAIL ADAPTERS
Before Installing the Canon supplied longitudinal ceiling rails, make sure that there is at least
35 in. [89 cm] between one end of the rails and any obstructions facing them. This will allow
the complete length of the adaptors to be rolled into the ceiling rails.
1.
Position each Rail Adaptor (left or right) so that the Bumper Stop is oriented toward the outside
of both Canon Ceiling Rails, then roll Rail Adapters into the inside channel of the Ceiling Rails
as shown in Figure 1.
Figure 1