Installation and Maintenance Guide for IDI Suspension System mounted to Canon DST-1000A Rails
L240-1429 REV A Image Diagnostics, Inc.
Page
6
C.
GENERAL SAFETY
Attention. Consult accompanying documents.
Failure to follow these instructions can cause accidents
resulting in serious injury to patient, user, and damage to
equipment.
Only qualified persons may install, operate or maintain this equipment.
Installation of this unit must adhere to applicable codes and authorities having any
jurisdiction over this installation. The customer's architect or engineer is responsible for
assuring that the structural support plans comply with all applicable codes and regulations.
The unit should be used only in rooms that comply with state, federal and local recommendations
concerning electrical safety when used in medical installations. All electrical connections shall be
done by licensed/approved electrician per national electric codes.
CAUTION:
• Always switch off mains before performing
nonelectrical tests or maintenance.
• Many positions exist where equipment or patient
collision may occur. Care must be exercised
during equipment positioning to avoid a patient or
equipment collision.
Changes and additions to the equipment may be performed only by an authorized representative.
These changes must conform to regulations and accepted standards of good practice. To prevent
defeat of the built-in safety mechanisms, changes must be submitted in writing to the manufacturer
for review.
Use only parts specified by Image Diagnostics, Inc. when repairing or servicing this equipment.
This equipment is intended to only be used with Image Diagnostics, Inc. Cross (transverse)
rails.