Download catalogs and CAD from http://asia.idec.com/downloads
E-090
APEM
Switches &
Pilot Lights
Control Boxes
Emergency
Stop Switches
Enabling
Switches
Safety Products
Explosion Proof
Terminal Blocks
Relays & Sockets
Circuit
Protectors
Power Supplies
LED Illumination
Controllers
Operator
Interfaces
Sensors
AUTO-ID
Saf
ety
P
ro
du
cts
Interlock
Switches
Non-contact
Interlock Switches
Safety Laser
Scanners
Safety Light
Curtains
Safety Modules
HS6B
HS6E
HS5D
HS5L
HS1L
Actuators for
HS1/HS5/HS6
Actuators/
Padlock Hasp
HS5 Series Padlock Hasp
• When using the HS9Z-PH5 for safety-related equipment in a con trol
system, refer to the safety standards and regulations in each country
to make sure of correct operation. Also, perform a risk assessment to
ensure safety before starting operation.
• Read the instruction sheet of the interlock switch to be used.
• Note the projections on the HS9Z-PH5 when using to prevent injury.
• Insert the HS9Z-PH5 in the direction as shown in the following fig ure.
Do not insert from any other direction. Also, do not use the slot plug
supplied with the interlock switch.
Actuator Entry Slot
Interlock Switch
HS9Z-PH5
• Do not deform the HS9Z-PH5. The HS9Z-PH5 may come off from the
interlock switch even if a padlock is installed. Stop using imme diately
if the HS9Z-PH5 becomes deformed.
• The shackle diameter of the applicable padlock (refer to the follow ing
figure) is ø5.5 to 7.5 mm.
Shackle Diameter
• When using a hasp or special padlock, make sure that the sliding tab
does not slide 3 mm or more in the direction shown below, oth erwise
the HS9Z-PH5 may come off the interlock switch.
3 mm
3 mm
Sliding Tab
Cover
Round Holes
Oblong Hole
• When using a hasp such as shown below, make sure that the hasp is
installed in round holes not in the oblong hole. Otherwise the sliding
tab may slide 3 mm or more. Check periodically that the narrow gap
between the jaws is not widened, so that the HS9Z-PH5 does not fall
off from the hasp.
Narrow Gap
• Keep the weight of padlocks and hasps to a maximum of 1500g on
one tab hole, and at a maximum of 3000g for the total of all tab holes.
Using padlocks and hasps weighing over the maximum allowable
weight may cause deformation of the HS9Z-PH5, and the interlock
switch may be damaged.
• Do not apply excessive shock to the HS9Z-PH5 while installing it on
the interlock switch, otherwise failure or damage may be caused.
• Do not apply excessive vibration while padlocks or hasps are
installed, otherwise failure or damage may be caused.
• The HS9Z-PH5 is used for HS5D/HS5E/HS5E-K/HS5L interlock
switches. Do not use the HS9Z-PH5 for any other products.
• Make sure that locking and unlocking the padlock and hasp do not
interfere with other products in close proximity.
• Do not modify or disassemble the HS9Z-PH5.
• Padlocks and hasps are available from the following manufactur ers.
Panduit Corporation (http://www.panduit.com/)
Master Lock Company (http://www.masterlock.com/)
Precautions for Installation
