For more information, visit http://asia.idec.com
E-083
APEM
Switches &
Pilot Lights
Control Boxes
Emergency
Stop Switches
Enabling
Switches
Safety Products
Explosion Proof
Terminal Blocks
Relays & Sockets
Circuit
Protectors
Power Supplies
LED Illumination
Controllers
Operator
Interfaces
Sensors
AUTO-ID
Saf
ety
P
ro
du
cts
Interlock
Switches
Non-contact
Interlock Switches
Safety Laser
Scanners
Safety Light
Curtains
Safety Modules
HS6B
HS6E
HS5D
HS5L
HS1L
Actuators for
HS1/HS5/HS6
Actuators/
Padlock Hasp
HS5 Series Slide Handle Actuator
When using HS5D
1. Using M4 mounting screws, fasten the HS5D interlock switch on the
switch base unit. Mounting screws are not supplied and must be
provided by the user.
Mounting screw thread length: 27 to 31mm
Switch Base Unit
Mounting Screws (M4)
HS5D Interlock Switch
2. Fasten the switch base unit on the mounting frame or panel.
Mounting screws and nuts are not supplied and must be provided by
the user.
Installing the rear unlocking button
• Install the rear unlock button kit for frame mounting (HS9Z-FL5
).
For detail, see the instruction sheet of HS9Z-FL5
.
• The button supplied with the HS5E-
L/HS5L-
L is not used. See
E-083
for applicable manual rear unlocking button kit for frame and
mounting part thickness.
Mounting Screw
(M6)
Manual Rear Unlocking
Button Kit for Frame
Switch Base Unit
Bolt Entry Slot
Mounting holes requiredon the frame
(see mounting hole layout)
Installing the handle unit
• Fasten
handle unit on the mounting frame or panel. Mounting
screws and nuts are not supplied and must be provided by the
user. Make sure that the bolt fits the bolt entry slot. See “Actuator
Mounting Reference Position.”
Handle Unit
Mounting Screws
(M6)
Installing the Actuator
• Insert
handle unit into
switch base unit.
• With
actuator stop lightly touching the interlock switch, install
actuator on the
handle unit using
spring washers and
one-
side screws.
Actuator Stop
Actuator
Spring Washer
One-side Screw
Handle Unit
• Make sure that the actuator is installed straight.
• Actuators have different mounting holes depending on the interlock
switch model. Using the mounting screws supplied with the actuator,
fasten the actuator referring to the figure below and the instructions
shown on the label on the actuator.
• One-way screw removal tool is needed for removing the attached
mounting screws (removal tool OW510 by SAIMA CORPORATION).
• After mounting the actuator, remove the actuator stop from the
interlock switch.
HS5D
mounting
holes
HS5E Mounting Holes
Actuator
Stop
HS5D Interlock Switch
HS5E
Interlock
Switch
5
Actuator Mounting Reference Position
• See below for the mounting reference position and allowable mounting range.
Reference Position
Reference Position
0.5mm
0.5mm
0.5mm
Bolt
Bolt Entry Slot
Installing the Rear Lever
• Fasten
rear lever onto
handle unit.
Rear Lever
Handle Unit
• Apply Loctite to the screw so that it does loosen.
• Mounting screws and nuts are not supplied and must be provided by
the user.
Operating Instructions
