Ideal AKE AKV 116, Operating Manual, Page: 159 / 168

Subject to technical changes | Valid from July 2021 Subject to technical changes | Valid from July 2021
75
REFRIGERATED DISPLAY CASES
1
2
No. Designation
1 Lock
2 Guide handle
Units with hot gas evaporation may only be operated with the condensate evaporation tray fully inserted and closed.
When removing the condensate evaporation tray, ensure that no water spills out. Wipe away any spilled water to pre -
vent damage to the unit.
NOTE
NOTE
Wear protective gloves for cleaning.
When cleaning the hot gas evaporation tray carry out the following steps:
1. Switch off the unit via the controller and pull the mains plug properly out of the socket, or disconnect the unit from
the mains at all poles.
2. Push the lock (no. 1) upwards with one hand. Pull it out forwards with one hand by means of the guide handle. The
condensate evaporation tray folds down.
3. Remove the condensate evaporation tray, empty it and clean it. Please use only the cleaning agents mentioned in
Chapter 4.1.2.
4. Replace the emptied and cleaned condensate evaporation tray. Ensure that the hot gas evaporation tray is fully
inserted.
5. Lift the guide handle with both hands and push it backwards. The condensate evaporation tray must be completely
folded upwards.
6. Check the locking mechanism; this must be closed.
7. Switch unit on.