ViVOpay Vend 3 User Guide
5
Installing the ViVOpay Vend 3
Installing the ViVOpay Vend 3
This section describes how to install the ViVOpay Vend 3, iris VRX. The basic steps are:
• Install SAMs if required
• Connect to power and POS
• Mount
• Test the installation
Connector and SAM Access
The ViVOpay Vend 3, iris VRX connectors and SAM slots are on the bottom of the reader.
To access the connectors
1. Turn over the ViVOpay Vend 3, iris VRX so that the connectors and SAM slots are visible.
PIN pad
Data and Power
Ethernet
SAM 2
SAM 3
SAM 4
Install a SAM Card
All ViVOpay Vend 3, iris VRX models have three SAM card slots in addition to one SoftSAM. In
Advanced Reader Firmware, the SoftSAM is SAM 1. Consequently, the physical SAMs are
labeled SAM 2 through SAM 4, left to right. If you are using a SAM card(s) in your application,
insert the SAM card as described in the following steps.
Warning:
Do not insert or remove a SAM card while the ViVOpay Vend 3, iris VRX is powered. This
will cause permanent damage to the SAM card.
To install a SAM card
1. Use your fingernail to slide the lock bar down, away from the connectors, and pull the SAM
cage away from the closed position. The cage hinges on the edge furthest from the
connector ports.
