Mounting and Installation
Wall Mounting Installation
The intercom is designed to be mounted on a wall. The following steps outline this procedure.
Tools
The following tools will be required to complete the installation:
⦁
L-shaped hex tool (supplied)
⦁
Phillips screwdriver (Ph2 or Ph3)
⦁
Electric impact drill with 6mm drill bit
⦁
Hammer
⦁
RJ45 crimper
Preparation
Prepare the installation area:
1.
Place the
wall mounting template
sheet on the wall where the
intercom
will be located.
2.
Drill 4 holes over the marks provided on the template. A drill hole
depth of 50mm is recommended.
3.
Remove the template and insert the screw anchors into the holes.
Mounting
1.
Pull the cable through the cable hole in the
back panel
, leaving 15-20cm excess cable length.
2.
With the L-shaped hex tool provided, remove the four security screws and lift the front plate out of the
enclosure.
3.
Using the 4 TA5 40mm screws, mount the
back panel
to the wall.
Note
: the intercom is equipped with a secondary cable hole at the bottom of the back panel.
PRT-IPIC-POE | Protege Vandal Resistant VoIP Intercom | Installation Manual
10
