ICT Protege PRT-IPIC-POE-C, Installation Manual

Page: 34 / 57

Intercom Settings
Intercom Settings | Features
⦁
Limit Talk Duration : When enabled, calls will automatically end after the maximum time.
⦁ Talk Duration : The maximum time (in seconds) for intercom calls.
⦁
DND Mode : Prevent incoming calls for the phone (all lines) or the line .
⦁ Ban Outgoing : When enabled no outgoing calls can be made.
⦁
Enable Call Waiting : When enabled allows users to answer a second incoming call.
⦁ Enable Call Waiting Tone : When enabled plays an intercom ring tone alerting to a waiting call.
⦁
Enable Intercom : When selected the device will accept the SIP header call information.
⦁ Enable Intercom Barge : When enabled automatically answer calls in intercom mode during a call if the
current call is intercom mode.
⦁ Enable Intercom Mute : When enabled mutes incoming calls during an intercom call.
⦁ Enable Auto Dial Out : Enables auto dial out on timeout.
⦁ Auto Dial Out Time : Set the wait time before auto dial out.
⦁ Enable Auto Answer : Enable the auto answer function and select the required line configuration.
⦁ Auto Answer Timeout : Set the auto answer timeout.
⦁ Dial Fixed Length to Send : When enabled requires a fixed length number to be entered when dialing.
⦁ Send Length : The number of digits required when Dial Fixed Length to Send is enabled.
⦁ Voice Read IP : Enable an IP voice broadcast.
⦁ System Language : Set the voice prompt language.
⦁ Description : The broadcast identification of the intercom.
⦁ Enable DND (Do Not Disturb) : Prevents incoming calls according to the DND Mode . Outgoing calls will not
be affected.
⦁ HangUp Delay : The duration (in seconds) that the intercom plays the hang up tone when a call is ended.
⦁ Call Timeout : The duration (in seconds) that the intercom will attempt a call before canceling.
⦁ Dial Number Voice Play : When enabled, the intercom will announce each number pressed on the keypad.
⦁ Ring Timeout : The duration (in seconds) before the intercom will cancel an unanswered incoming call.
Intercom Settings | Audio
Configure audio parameters such as voice codec, speaker volume, MIC volume and ringer volume.
Audio Settings
⦁ Codecs : Up to six codecs can be configured, in priority order.
Available audio codecs are: G.711A/U, G.722, G.723.1, G.726-32, G.729AB.
⦁ DTMF Payload Type : The RTP Payload type that indicates DTMF. Default is 101.
⦁ Default Ring Type : Select from 9 standard ring types.
⦁ G.729AB Payload Length : G.729AB payload length. Adjust from 10 – 60ms.
⦁ Tone Standard : Select which country's tone set should be used to indicate busy/ringing/hang up.
⦁ G.722 Timestamps : Select 160/20ms or 320/20ms.
⦁ G.723.1 Bit Rate : Select 5.3kb/s or 6.3kb/s.
Volume Settings
⦁
Speakerphone Volume : The volume level for broadcast audio.
⦁ MIC Input Volume : Configure the microphone volume level for audio when the intercom calls a phone.
⦁
Broadcast Output Volume : The volume level for audio received in phone calls.
PRT-IPIC-POE-C | Vandal Resistant VoIP Intercom with Camera | Installation Manual 34