Changing a parameter
After changing to the parameter, the
least significant digit
of the respective parameter flashes on
the display. This value can be changed with the
[
▼
] or [
▲
]-key
. To move to the next digit, the
[P]-
key
must be briefly pushed. Once the
most significant digit
has been set and confirmed with
[P]
,
the least significant digit will begin to flash again.
Saving of parameters
All parameters
must be acknowledged by the user by pushing the
[P]-key
for one second. The
changed parameters are then taken over as the current operating parameters and saved in the
EEPROM.
This is confirmed by
horizontal bars
lighting up in the display.
Example:
The 0 is flashing this is the least significant digit and
asks if you want to change it. Let us assume the figure
has to be changed from 75,640 to 75,000. Briefly push
the
[P]-key
to move to the next digit. The 4 begins to
flash. Change the figure by pushing
[
▼
] or [
▲
]-key
to
change the digit from 4 to 0. Briefly push the
[P]-key
to
move on to the next digit. The 6 begins to flash. Change the digit by pushing
[
▼
] or [
▲
]-key
to
move the 6 to a 0. Briefly push the
[P]-key
to move to the next digit. The 5 and 7 do not need to be
changed.
All
the
newly entered data are confirmed
by the unit. If no confirmation is received, the relevant
parameters have not been saved.
20
7. Programming
Example:
Save all parameters by pushing
[P]
for 2 seconds.
Example:
You receive confirmation from the unit that the
changes have been saved through the appearance of
horizontal bars in the middle segments.
7.1.1 Changing from programming mode into operating mode
If no key is pushed in the programming mode for about 7 seconds, the unit will return automatically
to operating mode.
