© 2011 ICS | Blount, Inc. Specifications and pricing are subject to change without notice. P/N 550416 REV06012011
660GC SERVICE MANUAL
41
12
This section covers the
removal and installation of the
carburetor. Removal of the air
intake components and cylinder
cover is required. Please refer
to sections 5 and 10 or 11 if
necessary. Carburetor tuning
is covered in section 22.
12.1 Remove throttle linkage.
A Push trigger end out of rear handle.
B Pivot linkage around.
C Remove carburetor end of linkage
from throttle rod tab on carburetor.
NOTE:
All saws are equipped with
carburetor model # HDA-225.
12.2 Remove fuel line from carburetor and
support bracker.
12.3 Remove carburetor support bracket.
A Remove carburetor support screw (1)
with #4 Torx or straight blade
screwdriver.
B Remove carburetor body screws (2).
12. CARBURETOR
A
B
B
