© 2011 ICS | Blount, Inc. Specifications and pricing are subject to change without notice. P/N 550416 REV06012011
660GC SERVICE MANUAL
31
8. STARTER
8.17 Remove starter pawl screws, pawls,
spring, and plain washer.
NOTE:
Piston stop tool may be required to
remove the starter pawl screws.
8.18 Inspect and clean pawl components.
A Inspect the components.
Replace if necessary.
B Clean the components with a brush
and solvent.
8.19 Assemble components.
A Make sure the spring is in the
correct position.
B Use Loctite
®
242 on the pawl screws.
C Torque to 60 in-lbs. (6.8 Nm).
8.20 Install starter cover.
A Pull out cord 4-6” (10 - 15 cm).
B Slowly release while placing cover
to allow pawls to engage.