5. Setting up the device
20
Menu level
Parameterisation level
Continuation
Via
totAL
the current value of the totaliser can be displayed, after this the device changes back
onto the parameterised display value. If
tot.rE
is deposited, the totaliser can be set back by
pressing the navigation keys
[
▲
] [
▼
]
, the device acknowledges this with showing
ooooo
in the
display. The configuration of
EHt.rE
deletes the min/max-memory. Under
ActuA
the measurand
is shown, after this the display returns to the parameterised display value. The brightness can
be adjusted with
light
. This adjustment is not saved and gets lost at a restart of the device. If
no
is selected, the navigation keys are without any function in the operation mode.
Special function [O]-key,
tASt.4:
Default:
no
For the operation mode, special functions can be deposited on the
[O]-key
. This function is
activated by pressing the key. With
tArA
the device is set temporarily on a parameterised value.
The device acknowledges the correct taring with
oo0oo
in the display.
Set.tA
adds a defined
value on to the currently displayed value. Via
totAL
the current value of the totaliser can be
displayed, after this the device switches back on the parameterised display value. If
tot.rE
was
deposited, the totaliser can be set back by pressing of the navigation keys
[
▲
] [
▼
]
, the device
acknowledges this with
ooooo
in the display.
EHt.rE
deletes the min/max-memory. If
HOLD
has
been selected, the moment can be hold constant by pressing the
[O]-key
, and is updated by
releasing the key.
Advice:
Hold
is activated only, if
HOLD
was selected under parameter
DISPL
.
ActuA
shows the measuring value, after this the device switches back on the parameterised
display value. The same goes for
AVG
, here the sliding average values will be displayed. The
constant value
const
can be recalled via the digital input, or changed digit per digit. At
AL-1
…
AL-4
an output can be set and therewith e.g. a setpoint adjustment can be done. If
no
is selected, the
[O]-key
is without any function in the operation mode.
Special function digital input,
dIG.In:
Default:
no
In operation mode, the above shown parameter can be laid on the optional digital input, too.
Function description see
tASt.4
.
Back to menu group level,
rEt
:
With
[P]
the selection is confirmed and the device changes into menu group level
„–fct–“
.
…
…
