2.5.1 Init/Normal DIP-Switch
The Init/Normal DIP-Switch is used to set the module run in the configuration mode or the
operation mode. After users get the module, the configuration generally needs to be done
first. Here is the description about the Configuration mode and the Operation mode.
Configuration mode:
This mode is used to set the UART or CAN communication
parameters for baud rate, data format, filter, etc. After finishing the configuration, all of
the parameters will be stored in the EEPROM of the CAN converters.
Operation mode:
This mode is used to convert the UART data and CAN messages with
each other. Users can also use the UART commands to get module information or
change some configuration of the UART or CAN parameters. Some of UART commands
like “P2” and “P3” for changing the configuration in the normal mode will not be stored in
the EEPROM. About the detail description, please refer to chapter 4 Command List.
The DIP-switch position for different modules may be different. The DIP-switch of the
I-7530/I-7530T, I-7530-FT, I-7530A, and I-7565 are on the back of the module, as following
figure.
The DIP-switch of the tM-7530 is in the bottom of the module.
Mode
Position
Normal
Init
I-7530, I-7530-FT, I-7530A, I-7565, tM-7530, tM-7530A, tM-7565 User Manual Version 1.5
Page
：
23
Copyright © 2018 ICP DAS Co., Ltd. All Rights Reserved E-mail: [email protected]
