Ethernet I/O Modules
ICP DAS CO., LTD.
PETL/tET/tPET DIO Series User Manual, Ver. 2.2, Aug. 2017, Page: 74
5.2 Two Modules Pushing the Local DI to each
other (1-to-1, Push mode)
Step 1: Connect the device to a Network, a PC and a Power supply.
Confirm that the PETL/tET/tPET series modules are functioning correctly. Refer to
Chapter 3 “Getting
Started”
for more details. An example configuration shown below:
Note that tPET-P2POR2 and tPET-PD2POR2 modules are used in this example.
Step 2: Configure the Ethernet Settings
Contact your Network Administrator to obtain the correct network configuration information for the
ET-2200 series modules (e.g., tPET-P2POR2 #1 and tPET-PD2POR2 #2), such as the IP Address, Subnet
Mask, and Gateway details. Refer to
Section 3.4 “Using the eSearch Utility to assign a new IP”
for
more details.
Figure 5-2.1
Figure 5-2.2
