IC
L
ive Users Manual - Models ICL-R & IC215S-R
32
Before going on you should first verify that the
correct measurement system is being used (feet
or meters). The default measurement system is
feet but you may want to use meters.
To check or change the setting, select Prefer-
ences from the Options pull down menu in the
tool bar section of RHAON or right click in the
center of the beam steering window.
If you want to change from feet to meters, click in
the Metric radio button.
Note that this window also allows you to control
the behavior of the Fault Relay and the Power-
On sequencing delay.
The Beam Steering tab contains the setting con-
trols for the appearance of the Beam Steering
window. The normal default setting are shown.
Notice that this setup window also allows you to
change the height of the measuring plane (the
Ear Height
). Until you are more familiar with the
program we suggest you accept the default set-
ting. There are times, however, when you will
want to change the height of the measuring
plane. It is set to 1.2 meters (3.94 feet) which is
fine for a seated audience, but not for a standing
audience.
The Mapping Appearance section allows you to
control the appearance of the main Mapping plot.
For now, we suggest using the default settings.
You can experiment
with various settings later.
The Scale Level Views section gives you control
over the scales used in the main Mapping win-
dow. Many experienced users like to use the
Fixed Range
option under
Scale Level Views
;
setting the
Round Up
to 5 and the
Show Range
to 5. You may want to experiment with this to see
which settings you like best.
We’ll investigate the other tabs later.
