13
13
13. Identify the Right Crank Axle (16).
Apply grease to the Right Crank Axle (16) and
to a Nylon Spacer (102). Then, slide the Nylon
Spacer onto the Right Crank Axle.
Insert the Right Crank Axle (16) into the right
Pedal Arm Bracket (44), and firmly tighten the
Right Crank Axle clockwise into the right arm of
the Crank (18).
Next,
firmly tighten the Right Crank Locknut
(36) and an M12 Split Washer (74) onto the
Right Crank Axle (16). Then, press a 19mm
Dome Cap (84) firmly onto the Right Crank
Locknut.
Repeat this step on the left side of the ellipti-
cal. Note: Turn the Left Crank Axle (not shown)
counterclockwise to tighten it, and use the Left
Crank Locknut (not shown).
84
36
74
Grease
102
16
18
44
12. Apply grease to an M10 x 70mm Bolt (60).
Attach the right Pedal Arm (11) to the right
Upper Body Leg (64) with the M10 x 70mm
Bolt (60), two M10 Washers (92), two M10
Plastic Washers (62), and an M10 Locknut (93)
as shown. Make sure to place the Plastic
Washers between the right Upper Body Leg
and the right Pedal Arm.
Then, press a 17mm Dome Cap (14) firmly onto
each M10 Washer (92).
Attach the left Pedal Arm (11) to the left
Upper Body Leg (64) in the same way.
12
14
60
92
92
11
11
64
62
64
93
14
Grease
