![background image](http://html1.mh-extra.com/html/icom/iv86/iv86_service-manual-addendum_4733731054.webp)
SECTION 1
SPECIFICATIONS
1-1
[USA-01]
[EXP-01], [EXP-03]
[THA-01]
G
E
NER
A
L
Frequency range
RX
136~174 MHz
144~147 MHz
TX
144~148 MHz
136~174 MHz
144~147 MHz
Operating mode
F2D, F3E
Number of memory channels
207 channels
(200 memory channels, 1 call channel, and 6 scan edge channels)
Scan types
Full, Program, Priority, Memory channel, Skip, and Tone
Selectable tuning setps
5, 10, 12.5, 15, 20, 25, 30, and 50 kHz
Usable temperature range
−20°C~+60°C (−4°F~+140°F)
Frequency stability
±2.5 ppm (−20°C~+60°C)
Power supply
Specified Icom's battery packs and case only
7.5 V DC (negative ground)
Current drain
(at 7.5 V DC)
RX Internal speaker
450 mA typical (Maximum audio)
External speaker
200 mA typical (Maximum audio)
TX Extra high power
1600 mA typical
−
High power
1400 mA typical
Middle power
1000 mA typical
Low power
500 mA typical
Antenna connector
BNC (50 Ω)
Dimensions
(projections not included)
With BP-298
58.6 (W)×112 (H)×30.5 (D) mm
(2.3 (W)×4.4 (H)×1.2 (D) inches)
With BP-264
58.6 (W)×112 (H)×26.0 (D) mm
(2.3 (W)×4.4 (H)×1.0 (D) inches)
Weight
(approximate)
300 g (10.6 oz, with BP-298 and FA-B57V)
360 g (12.7 oz, with BP-264 and FA-B57V)
T
R
A
NS
M
IT
T
E
R
Output power
(at 7.5 V DC)
Extra high power
7.0 W
7.0 W
*
1
−
High power
5.5 W
5.0 W
Middle power
2.5 W
Low power
0.5 W
Modulation system
Frequency shift keying modulation
Maximum frequency deviation
Wide
±5.0 kHz
Narrow
±2.5 kHz
Spurious emissions
Less than −60 dB
Microphone impedance
2200 Ω
R
EC
E
IV
E
R
Receive system
Direct Conversion
Sensitivity
*
2
(at 12 dB SINAD)
0.14 µV typical
Squelch sensitivity
*
2
(threshold)
0.11 µV typical
Adjacent channel selectivity
Wide
75 dB typical
Narrow
70 dB typical
Intermodulation
65 dB typical
Audio output power
Internal speaker
1.5 W typical (at 5% distortion into the 8 Ω load)
External speaker
0.55 W typical (at 5% distortion into an 8 Ω load)
*
1
For 144~160 MHz only.
*
2
The input signal strength level of this receive sensitivity is measured at the load end (PD).