![background image](http://html1.mh-extra.com/html/icom/ip110h/ip110h_operating-manual_2038205039.webp)
5
OPTIONS
5-5
Using a Bluetooth headset
You can connect to other Bluetooth headsets with the
built-in Bluetooth unit�
L
Only the VS-3 is guaranteed as of January 2022�
L
This function may be usable, depending on the
transceiver setting� (p� 5-5)
• The communication range of Bluetooth is
approximately 10 meters (33 feet)�
• Although you can enter up to 4 Bluetooth devices in
the transceiver device list, it is recommended that
you pair only one device at a time�
Electromagnetic Interference
When you use a Bluetooth device, pay attention to
the following:
Bluetooth devices operate in the 2�4 GHz band that
is also used by other appliances, such as Wireless
LAN products, microwave ovens, RFID systems,
amateur radio stations, and so on�
When using a Bluetooth device near such devices,
interference may occur, causing a decrease in
communication speed, and an unstable connection�
In such case, keep the Bluetooth devices away from
the other appliances, or stop using those devices�
Bringing the Bluetooth device and the transceiver
closer together also improves communication�
D
About the VS-3 Bluetooth headset
When you connect an optional VS-3 Bluetooth
headset to the transceiver, you can wirelessly transmit
and receive the headset audio�
The VS-3 has a [PTT] switch, so you can transmit in
the same way as using the transceiver’s [PTT] switch.
NOTE:
• If the headset does not work correctly, even if the
headset is turned ON, push [RESET] with a pin to
force power OFF�
• When the volume is set to too low, the audio may
not be loud enough to hear� Setting the volume
level to “28” or higher is recommended�
Function
Operation
Beep tone
Indicator
Power
ON
Hold down [PWR] for 3
seconds�
Melody (up)
Blinks blue
OFF
Melody (down)
OFF
Pairing mode
Searching
While the VS-3 is OFF, hold
down [PWR] for 6 seconds�
PiPa-
(ready to connect)
Quickly blinks red then blue, every
3 seconds
Connected
PiRo
Blinks blue twice, every 3 seconds
Transmit*
1
Push [PTT]
Pi*
2
Blinks red once, then blue twice,
every 3 seconds
Audio volume
Up*
1
Push [VOL] (+)
Pi
–
Down*
1
Push [VOL] (–)
Boo
–
*
1
You can use only when a Bluetooth headset is connected to the transceiver�
*
2
Depends on the Notice Tone settings or Bluetooth PTT Beep setting in the Controller�
Earphone jack (3�5 mm (1/8 inch))
Clip
[FWD]*
[PLAY]*
[RWD]*
[RESET]
Charging port
[PWR]
Indicator
[VOL] (–)
[VOL] (+)
[PTT]
Microphone
* One of the functions described on page 3-9 may be
assigned to the key, depending on the Controller setting�
Bluetooth
VS-3
(option)