Icom IC-M801E, Instruction Manual

Page: 48 / 80

40
10
DSC MENU OPERATION
2001 NEW
■
Verifying self-ID
➥
During setup select menu indication, rotate [CH] to
select “
MMSI check ” then push [ENT] to dis-
play the programmed MMSI ID (self-ID).
➥
Push [DSC] to select DSC watch mode.
➥
Push [MODE
SET
] to select DSC menu.
➥
Rotate [CH] to select “ Set up ” then push [ENT].
• Push [MODE
SET
] to return to DSC watch mode, or
push [FREQ/CH] to return to the select screen.
* * * * * * * * S e t u p * * * * * * * *
- - - - - - M M S I c h e c k - - - - - -
I D : 1 2 3 4 5 6 7 8 9
O K C an c e l
■
Telephone number input
q
During DSC menu indication, rotate [CH] to select
“
Set up ” then push [ENT] to select setup menu.
• The select screen is displayed.
w
Rotate [CH] to select the “ Number ,” then push
[ENT].
• The telephone number list screen is displayed.
• 10 telephone number memories are available.
e
Rotate [CH] to select “ <add> ” then push [ENT].
• The call/traffic/scan frequency setup screen is dis-
played.
r
Push the numeral keys to input the desired 10-
character telephone number name, and telephone
number, then push [ENT].
• Rotate [CH] to move the cursor.
* * * * * * * * S e t u p * * * * * * * *
- - - - - - - - N u m b e r - - - - - - - -
N a m e : † _ _ _ _ _ _ _ _ _
N u m b e r : _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
O K C an c e l
* * * * * * * * S e t u p * * * * * * * *
- - - - - - - - N u m b e r - - - - - - - -
< a d d >
T e s t 1
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6
T e s t 2
6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1
S E L O K
Ç
C an c e l
■
Self testing
According to regulations, the IC-M801E has a self test-
ing capability to check the internal AFSK encoder and
decoder circuits without signal transmission via the
transceiver.
q
During DSC watch mode, push [MODE set] to se-
lect DSC menu.
w
Rotate [CH] to select “ Self test ” then push
[ENT] to start the self test.
e
“ OK ” is displayed when both encoder and decoder
functioning correctly.
If the circuit has a problem, the following message
is displayed.
• Both or either message is/are displayed depending on
problem.
DSC-RX NG : DSC receiver’s decoder circuit has a
problem.
TRANSC NG : Transceiver’s encoder or decoder
circuit has a problem.
* * * * * * S e l f t e s t * * * * * * *
D S C - R X N G
T R A N S C N G
O K C an c e l
* * * * * * S e l f t e s t * * * * * * *
O K
O K C an c e l
* * * * * * S e l f t e s t * * * * * * *
T e s t i n g . . .
O K C an c e l
IC-M801E_0.qxd 05.12.2 16:32 Page 40