Icom IC-M801E, Instruction Manual

Page: 22 / 80

6
14
DSC PREPARATION
2001 NEW
■
MMSI code programming
The 9-digit MMSI (Maritime Mobile Service Identity:
DSC self ID) code can be programmed. This operation is not available when the MMSI code
has been programmed by your dealer. The code re-
programming cannot be performed. This code is dis-
played during DSC watch mode.
D D
Programming
q
The following screen will be displayed briefly at
power ON when no MMSI code is programmed.
w
Push [DSC] to select MMSI code programming
condition.
e
Enter the specified 9-digit MMSI code via the key-
pad.
• Make sure the correct code is entered.
• Rotate [CH] to move the cursor.
r
Push [ENT] to program the code.
• After pushing [ENT], DSC menu is displayed as below.
t
Push [MODE
SET
] to exit the DSC menu.
* * * * * * * * S e t u p * * * * * * * *
- - - - - - - - S e l e c t - - - - - - - -
G r o u p I D
C a l l f r e q u e n c y
T r a f f i c f r e q u e n c y
S c a n f r q e u e n c y
N u m b e r
M M S I c h e c k
Ç
O K S E L
* * * * * * * * S e t u p * * * * * * * *
- - - - - - - - - M M S I - - - - - - - - -
I D : 1 2 3 4 5 6 7 8 9
O K
* * * * * * * * S e t u p * * * * * * * *
- - - - - - - - - M M S I - - - - - - - - -
I D :
†
_ _ _ _ _ _ _ _
O K
< M M S I >
N o M M S I !
[MODE
SET
] [ENT]
[DSC]
IC-M801E_0.qxd 05.12.2 16:32 Page 14