SECTION 1 SPEC I F I CATI ONS
GE N E R A L
Number o f Sem iconductors
Number of Channels
Channel Spacing
Frequency Stability
Usable Temperature
Antenna Impedance
Power Supply Requirement
Current Drain at 8.4V
D imensions
Weight
R E C E I V E R
Frequency Range
Receiving System
Modulation Acceptance
Intermediate Frequency
Sensitivity
Squelch Sensitivity
Spurious Response Rejection Ratio
Selectivity
I
ntermodu lat ion Rejection Ratio
Audio Output Power
Audio Output Impedance
T R A NSMI TTE R
Frequency Range
Output Power
Em ission Mode
Modulation System
Max. Frequency Deviation
Spurious E mission
Microphone
Transistors
F E T
IC
45
3
5
Diodes
16 (not including diodes on the matrix board)
12 programmable channels
Operation Simplex, Semi-duplex
30KHz ( 15KHz optional)
0. 0005 Percent
-20 Degrees C to 60 Degrees C
( -4 Degrees F to 140 Degrees F)
50 ohms unbalanced
DC 8.4V; with attendant power pack IC-CM3, DC 6 to 12V
negative ground is acceptable
Transmitting
At 2. 5 watts output
Approx. 700mA
Receiving
At max audio output
Approx . 130mA
Squelched
Approx.
25mA
116. 5mm(H) x 65mm (W) x 45mm ( D) without power pack
Attendant power pack, IC-CM3: 49mm (H) x 65mm(W) x 35mm ( D)
5 10g including power pack, IC-CM3 and flexible antenna
150. 8
�
159. 0MHz or 160.0
�
166. 0MHz
Double-conversion superheterodyne
16F3
±
7
.
5KHz (F3E 16KO)
1st:
2nd:
10. 695MHz
455KHz
Less than 0.5µV for 20d 8 noise quieting
Less than 0.4µV for 12dB S I NA D
Less than 0.4µV
More than 50d8
More than 65d8 at adjacent channel
More than 60d 8
More than 300mW a t 10% distortion
8 ohms
15 0. 8
�
159. 0MHz or 160. 0
�
166.0MHz
2.5 watts (with IC-CM3), 4 . 0 watts (with IC-CH5)
16F3 (F3E 16KO)
Variable reactance frequency modulation
±5KHz
More than 57d 8 below carrier
Built-in electret condenser microphone
Optional spea ker-microphone ( IC-CM9) can be used
1
-
1
