■
Individual call
Receiving
APCO P25 Mode Operation
■
Individual call
Transmitting
Individual call allows you to make a call to a specific
station, and it provides private communication.
[Individual] key assignment is necessary to transmit
the Individual call.
1
Push [Individual] to enter the Individual ID
Receiving
1
When an Individual call is received;
• The Busy indicator lights green.
• The ringer sounds. (Depending on the pre-
setting.)
• The calling station ID (or name) is displayed for
2 sec. (Depending on the pre-set value.)
• Depending on the pre-set value, the transceiver
d
t
th l h d
i ti
1
Push [Individual] to enter the Individual ID
selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed, the ID
code is displayed.
• Push again to cancel and return to normal
operation.
does not open the squelch, and communication
is not established, if the Individual ID or NAC
(Network Access Code) is not matched.
2
Select the desired Individual ID (or name) using
[CH Up]/[CH Down] or [CH Up/Down].
• The Individual ID can be edited with the
10- keypad*. (Depending on the pre-set value.)
The calling station name ( or ID )
2
Push and hold [PTT] and speak into the
microphone.
3
Release [PTT] to receive a response.
▒
For P25 Trunking mode operation:
▒
When the Full Off Air Call SetUp (FOACSU) function
*10-key models only.
▒
To edit the Individual ID using the 10-keypad:
▒
Input the Individual ID directly with the 10-keypad.
▒
• Push [ ] to clear a code.
▒
▒
▒
▒
▒
When the Full Off Air Call SetUp (FOACSU) function
▒
is turned ON, beeps sound after receiving a call. In
▒
that case, push [PTT] to accept the call. Then,
▒
operate as described in steps
②
and
③
above. If
▒
you ignore the call by not pushing [PTT] for a
▒
specified time period*, communication is not
▒
established. Or, pushing [Home] after receiving the
▒
call will also ignore it.
▒
3
Push and hold [PTT] to transmit the Individual call
to the target station, then speak into the
microphone.
• The Transmit indicator lights red.
• Depending on the pre-set value, the target station
does not open the squelch, and communication
■
Talkgroup call
Transmitting
A Talkgroup call allows you to make a call to a
specific group only. [Talkgroup] key assignment is
necessary to transmit the Talkgroup call.
✔
For Trunking mode operation:
is not established, if the Individual ID or NAC
(Network Access Code) is not matched.
4
Release [PTT] to receive.
g
p
The [Talkgroup] key is not usable while in the
Trunking mode. To make a Talkgroup call, the group
affiliation should be performed with the desired
Talkgroup ID to call.
1
Push [Talkgroup] to enter the Talkgroup ID
(or name) selection mode.
• A pre-programmed ID name is displayed.
45
• When the ID name is not programmed, the ID
code is displayed.
• Push again to cancel and return to normal
operation.
