![background image](http://html2.mh-extra.com/html/icom/ic-a210/ic-a210_instruction-manual_3448365031.webp)
27
5
MENU MODE
D
Beep Tone Level “BEEP”
Confirmation beep tones normally sound when storing mem-
ory, operating time-out-timer function, etc. These can be set
a desired beep level as you prefer.
• OFF (0)
: The beep tone turns OFF.
• 001 to 100 : Setting the beep tone level from 1 to 100.
D
Intercom Usable Setting “INCOM MODE”
Set the intercom using or not.
• ON
: The intercom is usable.
• OFF
: The intercom is unusable.
D
Time-Out-Timer “TIME OUT”
To prevent accidental prolonged transmission, the trans-
ceiver has a time-out-timer function. This timer starts when a
transmission begins, and will cut off the transmission when
the time set in the timer elapses.
• 020 to 240 : Setting time-out-timer starting period from 20 sec-
onds to 240 seconds in 10 secons intervals.
D
Frequency Step “FREQ. STEP”
Set the desired frequency step: 8.33 kHz or 25 kHz.
• 25kHz
: Setting the frequency step to 25 kHz.
• 8.33kHz
: Setting the frequency step to 8.33 kHz.
D
Interlock “INTERLOCK”
When two transceivers are connected together, the interlock
function can prevent them from transmitting at the same
time.
• TX INHIBIT : Transmission is prevented.
• RX MUTE
: Audio output is prevented.
• BOTH
: Transmission and audio output are both prevented.
D
Memory Clear “MEM CLEAR”
Set values in the CPU are cleared.
Hold down
[MEM] for 2 seconds, the CPU is reset as follows.
• MENU
: MENU mode items are reset.
• MEMORY
: Stored memories are reset.
• ALL
: All CPU data is reset.
0
5
NOTE:
When using an external speaker, the beep tone
level when the squelch is closed is fixed and cannot be
changed in the MENU mode.
NOTE:
The interlock does not appear when the “TX/RX
INTERLOCK SW” is set to “DISABLE,” by the CS-A210.