10
3
MEMORY OPERATION
■
Programming a memory
channel
To program the memory channels, follow the steps below.
q
Rotate
[DIAL] and [O-DIAL] to set a desired frequency
for the standby frequency.
w
Push
[RCL] to enter the memory mode.
• The channel number appears.
• The memory channel name also appears if it has been entered.
e
Rotate
[O-DIAL] to select a desired memory channel
type.
• Select regular memory channel or group memory channel.
r
Push
[MEM], and then rotate [O-DIAL] to select the “RE-
PLACE” menu.
• The memory channel number blinks.
t
Rotate
[DIAL] to select a memory channel to be pro-
grammed.
y
Push
[MEM], to program the frequency into the channel.
• “WRITE COMPLETED” appears on the display when the regu-
lar memory channel is programmed.
u
Push [RCL] to exit the memory mode.
■
Channel selection
The transceiver has 10 channels in regular memory and 200
channels in the group memory. There are 10 channels in
each of 20 groups (GRP01–GRP20).
q
Push
[RCL] to enter the memory mode.
• The channel number appears.
• The memory channel name also appears if it has been entered.
w
Rotate
[O-DIAL] to select the memory channel type.
• Select from regular memory channel or group memory channel.
e
Rotate
[DIAL] to select a desired memory channel
number.
Transferring the memory channel to the active fre-
quency is necessary if you want to operate on the
memory channel frequency.
Refer to “Transferring memory contents” (p. 12) for
details.
r
Push
[RCL] to change to standby frequency to the se-
lected memory channel frequency and exit the memory
mode.
CH01
127.00
5
122.00
RX
MEMORY
NOTE:
Hold down
[RCL] for 2 seconds to exit the mem-
ory mode without changing the previously set standby fre-
quency.
