![background image](http://html2.mh-extra.com/html/icom/ic-705/ic-705_basic-manual_4085731010.webp)
ix
BASIC MANUAL
R
DANGER HIGH RF VOLTAGE! NEVER
touch an
antenna, an antenna connector, or a ground terminal
while transmitting. This could cause an electrical
shock or burn.
R
DANGER! NEVER
operate the transceiver near
unshielded electrical blasting caps or in an explosive
atmosphere. This could cause an explosion and
death.
R
DANGER! NEVER
use or charge Icom battery
packs with non-Icom transceivers or non-Icom
chargers. Only Icom battery packs are tested and
approved for use with Icom transceivers or charged
with Icom chargers. Using thirdparty or counterfeit
battery packs or chargers may cause smoke, fire, or
cause the battery to burst.
R
WARNING RF EXPOSURE!
This transceiver
emits Radio Frequency (RF) energy. Extreme
caution should be observed when operating this
transceiver. If you have any questions regarding
RF exposure and safety standards please refer to
the Federal Communications Commission Office of
Engineering and Technology’s report on Evaluating
Compliance with FCC Guidelines for Human Radio
Frequency Electromagnetic Fields (OET Bulletin 65).
R
WARNING! NEVER
hold the transceiver so that
the antenna is very close to, or touching exposed
parts of the body, especially the face or eyes, while
transmitting. If the antenna is close to you, transmit
with low power.
R
WARNING! NEVER
operate the transceiver with
earphone, a headset, or other audio accessories at
high volume levels. If you experience a ringing in
your ears, reduce the volume or discontinue use.
R
WARNING! NEVER
apply AC power to the
[DC 13.8 V] jack on the transceiver side panel. This
could cause a fire or damage the transceiver.
R
WARNING! NEVER
apply more than 16 V DC to
the [DC 13.8 V] jack on the transceiver side panel.
This could cause a fire or damage the transceiver.
R
WARNING! NEVER
reverse the DC power cable
polarity. This could cause a fire or damage the
transceiver.
R
WARNING! NEVER
remove the fuse holder on
the DC power cable. Excessive current caused by a
short could cause a fire or damage the transceiver.
R
WARNING! NEVER
let metal, wire or other
objects contact the inside of the transceiver, or make
incorrect contact with connectors on the side panel.
This could cause an electric shock or damage the
transceiver.
R
WARNING! NEVER
operate or touch the
transceiver with wet hands. This could cause an
electric shock or damage to the transceiver.
R
WARNING! NEVER
operate the equipment if
you notice an abnormal odor, sound or smoke.
Immediately turn OFF the power and/or remove the
battery pack and the DC power cable. Contact your
Icom dealer or distributor for advice.
R
WARNING! NEVER
put the transceiver on an
unstable place where the transceiver may suddenly
move or fall. This could cause an injury or damage
the transceiver.
R
WARNING! NEVER
operate the transceiver
during a lightning storm. It may result in an electric
shock, cause a fire or damage the transceiver.
Always disconnect the power source and antenna
before a storm.
CAUTION: DO NOT
expose the transceiver to
rain, snow or any liquids. They could damage the
transceiver.
CAUTION: DO NOT
operate the transceiver unless
the flexible antenna, battery pack, and jack covers
are securely attached to the transceiver, and that the
antenna and battery pack are dry before attachment.
Exposing the inside of the transceiver to dust or
water will result in serious damage to the transceiver.
CAUTION: DO NOT
operate the transceiver while
driving a vehicle. Safe driving requires your full
attention—anything less may result in an accident.
CAUTION: DO NOT
short the terminals of the
battery pack. Shorting may occur if the terminals
touch metal objects such as a key, so be careful
when placing the battery packs (or the transceiver) in
bags, and so on. Carry them so that shorting cannot
occur with metal objects. Shorting may damage not
only the battery pack, but also the transceiver.
CAUTION: DO NOT
change the internal settings
of the transceiver. This could reduce transceiver
performance and/or damage to the transceiver. The
transceiver warranty does not cover any problems
caused by unauthorized internal adjustments.
CAUTION: DO NOT
install or place the transceiver
in a place without adequate ventilation, or block
any cooling vents on the rear of the transceiver.
Heat dissipation may be reduced and damage the
transceiver.
PRECAUTIONS
Summary of Contents for IC-705
Page 95: ...VI BASIC MANUAL MEMO...