![background image](http://html2.mh-extra.com/html/icom/ic-705/ic-705_basic-manual_4085731041.webp)
4-8
BASIC MANUAL
RECEIVING AND TRANSMITTING
4
4
Noise Reduction
The Noise Reduction function reduces random
noise components and enhances signal audio.
1. Push
.
• Opens the FUNCTION screen.
2. Touch [NR].
L
Touching [NR] turns this function ON or OFF.
3. To close the FUNCTION screen, push
.
D
Adjusting the Noise Reduction level
Adjust the Noise Reduction level to where
noise is reduced but the received signal is not
distorted.
1. Push
.
• Opens the FUNCTION screen.
2. Touch [NR] for 1 second.
• Turns ON the Noise Reduction function and
opens the NR menu.
3. Rotate
to adjust the Noise Reduction
level to between 0 and 15.
L
Adjust to a higher level to increase the
reduction level, and a lower level to decrease it.
4. To close the NR menu, push
.
Setting the transmit filter width
SSB mode
The transmit filter width for the SSB and SSB-D
modes can be set. WIDE (wide), MID (middle),
or NAR (narrow) can be selected only in the
SSB mode.
L
The filter can be independently set on the speech
compressor function is ON or OFF.
To change the filter width in the SSB mode:
1. Set the operating mode to USB or LSB.
2. Push
.
• Opens the FUNCTION screen.
3. Touch [TBW].
L
Touching [TBW] sets the filter width to WIDE,
MID, or NAR.
The transmit filter widths are set to the following
values by default.
•SSB (WIDE): 100 Hz to 2900 Hz
•SSB (MID): 300 Hz to 2700 Hz
•SSB (NAR): 500 Hz to 2500 Hz
•SSB-D:
300 Hz to 2700 Hz
L
You can change the filter width values in the
following settings.
» SET > Tone Control/TBW > TX > SSB
>
TBW (WIDE)
» SET > Tone Control/TBW > TX > SSB
>
TBW (MID)
» SET > Tone Control/TBW > TX > SSB
>
TBW (NAR)
» SET > Tone Control/TBW > TX > SSB-D
>
TBW
NR is OFF
NR level 0
NR is ON
NR level 4
Noise components
Desired signal (CW)
Displayed
when the Noise
Reduction
function is ON.
Summary of Contents for IC-705
Page 95: ...VI BASIC MANUAL MEMO...