![background image](http://html2.mh-extra.com/html/icom/d-star-id-4100a/d-star-id-4100a_manual_3513747015.webp)
14
D-STAR OPERATION
New2001
D-STAR GUIDE
New2001
■
Accessing repeaters
This section describes how to check whether or not you can
access your local area repeater (Access repeater), and if
your signal is successfully sent to a destination repeater.
Step 1: Set “FROM” (Access repeater)
1. Hold down [DR] for 1 second to display the DR screen.
2. Select “FROM,” then push [
ï
].
•Displays the FROM SELECT screen.
L
On the DR screen, pushing [DR] toggles between “FROM”
and “TO.”
3. Rotate [DIAL] to select “Repeater List,” then push [
ï
].
•Displays the REPEATER GROUP screen.
4. Select the repeater group where your access repeater
is listed, then push [
ï
].
5. Select your access repeater, then push [
ï
].
(Example: “Hirano”)
• Returns to the DR screen, and the selected repeater name is
displayed in “FROM.”
TIP:
If your call sign (MY) has not been set, or your
call sign and equipment have not been registered at a
D-STAR repeater, see pages 9 ~ 12.
Step 2: Set “TO” (Destination)
1. Push [DR] to select “TO,” then push [
ï
].
•Displays the TO SELECT screen.
2. Rotate [DIAL] to select “Gateway CQ,” then push [
ï
].
•Displays the REPEATER GROUP screen.
3. Select the repeater group where your destination
repeater is listed, then push [
ï
].
4. Select your destination repeater, then push [
ï
].
(Example: “Hamacho”)
• Returns to the DR screen, and the selected repeater name is
displayed in “TO.”
☞
Continued on the next page.
L
Even if you select just the repeater name, the repeater call
sign, its frequency, duplex setting, frequency offset and
Gateway call sign are automatically set.