32
TROUBLESHOOTING
New2001
D-STAR GUIDE
New2001
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
After your call, the repeater
replies ‘RPT?’ and the destination
repeater’s call sign.
• The repeater cannot connect to the
destination repeater.
• The repeater is busy.
• Check the repeater setting.
• Wait for a while, and try it again.
—
Even holding down [DR], the DR
screen is not displayed.
•There is no repeater list in your transceiver.
•The Lock function is activated.
• Import the repeater using a microSD card.
• Directly enter the Repeater list data into the
transceiver.
• Hold down [LOCK] for 1 second to turn OFF
the Lock function.
p. 25
AM*
Sec. 4
—
Even holding down [RX→CS], the
received call sign will not set to the
destination call sign.
• The call sign has not been correctly
received.
• When a received signal is weak, or a signal
is received during scanning, the call sign
may not be received correctly. In that case,
“--------” is displayed and error beeps sound,
and a reply call cannot be made.
Try it again, after the transceiver has correctly
received the call sign.
—
A Local area call can be made,
but the Gateway call or destination
station call cannot be made.
• MY call sign has not been registered on a
D-STAR repeater.
• The repeater set in “FROM” (Access
Repeater) has no Gateway.
•
Register your own call sign (MY) on a gateway
repeater, or confirm the registration of the call
sign.
• Check the repeater setting.
p. 11
“L” is displayed on the LCD.
While receiving through the internet, some
packets may be lost due to network error
(poor data throughput performance).
Wait a while, and try it again.
L
When the transceiver receives corrupted
data, and misidentifies it is as Packet Loss,
“L” is displayed, even if it is a Local area call.
—
“DV” and “FM” icons alternately
blink.
While in the DV mode, an FM signal is
received.
Use a different operating frequency until there
are no FM signals on the original frequency.
AM*
Sec. 4
* “AM” indicates the PDF type Advanced manual.
