![background image](http://html2.mh-extra.com/html/icom/d-star-id-4100a/d-star-id-4100a_manual_3513747032.webp)
New2001
31
New2001
New2001
TROUBLESHOOTING
D-STAR GUIDE
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
After your call, the repeater does
not return a status reply.
•The repeater setting is wrong.
• Your transmission did not reach the repeater.
•Select the correct repeater.
• Correct the repeater frequency, frequency
offset, or duplex settings.
• Wait until you are closer to the repeater and
try again.
•Try to access another repeater.
p. 28
—
—
—
After your call, the repeater replies
‘UR?’ and its call sign.
The call was successfully sent, but no station
immediately replied.
Wait for a while, and try again.
—
After your call, the repeater replies
‘RX’ or ‘RPT?’ and the access
repeater’s call sign.
•
Your own call sign (MY) has not been set.
•
Your own call sign (MY) has not been
registered on a gateway repeater, or the
registered contents do not match your
transceiver’s setting.
•
Set your own call sign (MY).
•
Register your own call sign (MY) on a gateway
repeater, or confirm the registration of the call
sign.
p. 9
p. 11
After your call, the repeater replies
‘RPT?’ and the access repeater’s
call sign.
The call sign of the destination repeater is
wrong.
Correctly set the destination repeater call sign.
—
■
When receiving no reply
To communicate through the repeater, your signal must access to the repeater. The following chart is designed to help you
correct problems which are not equipment malfunctions.