Ice vulcan, Service Manual

Page: 69 / 252

4-20 Installing the Label Applicator
ICE Vulcan Service Manual
26
Secure the waste label backing to the waste mandrel by slotting
the backing into the slot as indicated by the arrows on the waste
mandrel.
Mandrel Lock
Note: Right Hand unit shown
Figure 4-21: Mandrel Slot
27
Secure with the mandrel lock (a click sound is audible when
secured) and wind the label web around the mandrel two or three
times until the label web is secure.
Note: If the mandrel lock is not secured, the label speed will not be
accurate.
28
Place the supply disc on the supply mandrel and lock it if not
already completed.
For information on removing the ribbon and labels from the LPA,
refer to “How to Replace Label and Ribbon Web” on page 6-30.
Loading a Ribbon Roll on to the Ribbon Supply Mandrel
29
Remove the new ribbon from its packaging.
30
Unwind approximately 300 mm of ribbon from the reel (an
initial length of the ribbon is ink free and is termed 'leader').
31
Fit the new ribbon to the supply mandrel, and ensure that the
reel is pushed fully onto the mandrel.