6-10
Maintenance
Rev AA
ICE Vulcan Service Manual
CLARiTY Update via USB Memory Stick
Updating of LPA software is possible from a USB memory stick as
opposed to a PC/Laptop and CLARiTY Configuration Manager.
Do the following tasks to update the CLARiTY using a USB stick:
1
Copy the CLARiTY software onto a USB memory stick.
Note:
The software must be stored in a root directory called
‘\CLARiTYupdate’.
2
Connect the stick to the CLARiTY Operator Interface via the USB
port (see Figure 6-6).
USB Port
Figure 6-6: USB Location
3
If the CLARiTY Configuration Manager parameter called “Prompt
On CLARiTY Update Detect“ is set to
Yes
, when the device is
connected to the CLARiTY Operator Interface, a confirmation page
appears.
4
If the parameter is set to
No
, navigate to
Tools > Setup >
Control
and touch the
CLARiTY Update
button.
5
Select
Yes
to proceed to the next stage of the update or
No
to
return to the home page.
Summary of Contents for vulcan
