IBR C200, Instruction Manual, Page: 15 / 47

15
Instruction Manual C200
2.7 Connecting a foot or hand switch
The foot or hand switches are connected to the Sub-D ports Ft1 and Ft2 of the IMB-mc1 measuring
controller. Foot and hand switches can be cascaded in order to synchronize several column gauges
( e.g. for dynamic measuring ) by using a foot or hand switch connected to the
Ft1 or Ft2 connector.
The Y-Adapter ( Part No. F121 190 ) can then be used for cascading.
A third foot or hand switch (
Ft3 ) can be connected directly to the IMBus. An IMB foot or hand switch
is used in order to do so. It provides an IMBus connecting part and can be inserted into the IMBus at any
place behind the
IMB-mc1 ( see illustration below ).
The functions of the foot or hand switches can be configured in the “BASIC SETUP”
menu ( L3 -L5 ).
Types of foot or hand switches : Part No.
Foot switch IP32 .................................... F121 110
Foot switch IP65 ................................... F121 120
IMBus foot switch IP32 ......................... F121 130
IMBus foot switch IP65 ......................... F121 140
Hand switch IP65................................... F121 150
IMBus hand switch IP65 ....................... F121 160
Important !!!
Secure all connections by screwing them tight.
Plug-in connector pin assignments :
see chapter 6
2.8 Connecting adapters for tolerance outputs
The adapters for the tolerance-controlled
outputs are connected at the rear of the
column gauge to the
Ft1 or Ft2 Sub-D ports
of the IMB-mc1 measuring controller.
A total of 5 tolerance-controlled outputs are available:
1. Upper tolerance limit ( red ) exceeded
2. Upper intervention limit ( yellow ) exceeded
3. Measured value OK
4. Below lower intervention limit ( yellow )
5. Below lower tolerance limit ( red )
Connection adapter : Part No.
High-Side Power-FET OA-adp ..... F603 010
For adapter pin assignment of OA-adp
see chapter 6; for more information on the adapter
see Data Sheet, Doc. D2MF603 010
.
Ft1
Ft2
Ft2
Ft3
Ft1
RS232
IMB foot switch