34
Instruction Manual C100
8. Safety Instructions
The present instrument is state-of-the-art design and complies with the current safety standards. It is
nevertheless mandatory to observe the following instructions in order to prevent personal injuries or
accidental death of staffmembers and other persons.
1. All operators must read the present instructions and this manual very carefully
before starting
operation.
2. The instrument may be used only
in errorless technical condition.
Disruptions which may be
a danger to operational safety must be removed immediately.
3. The device may be used only as stated in these instructions. The manual must be kept near at
hand
at the place of operation.
4. Before connecting the device to the power outlet, make sure that the voltage indicated on the label
corresponds to the voltage of the local power net. If this is not the case, the device should under no
circumstances be connected to the power outlet.
5. The instrument must be connected to the power supply through a properly grounded safety socket.
Extension cables, where required, must comply with the VDE safety standards.
6. Any modification and procedures concerning the instrument are permitted only with the prior written
consent of
IBR Messtechnik GmbH & Co. KG
and must be carried out by competent staff.
Opening the case or tampering with the device without prior permission will lead to the loss of the
guarantee and free the producer from all liabilities. Before opening the instrument, make sure to
effectively cut the power supply, eg. by disconnecting the power cable.
7. Before cleaning, disconnect the instrument from the power supply. No liquids should ever be
allowed to leak inside the instrument. Strictly avoid the use of cleaners that attack plastic.
8. Replace faulty fuses only with fuses of identical amperage and current characteristics following the
instructions given in this manual.
9. Corporate guidelines and safety regulations enforced by the industrial trade associations for the
prevention of industrial accidents must be strictly observed. Make sure to consult the safety officer
at your company.
10.
Do not operate the instrument in an environment containing explosive gases, because an electric
spark can cause an explosion.
We reserve the right to change the design and technical data contained in our documentation without
notifying our customers. IBR is not obliged to notify changes of the products to previous buyers.
IBRit
is a registered trademark of IBR.
EXCEL
is a registered trademark of Microsoft Corporation.
All parts of this document must not be reproduced without written permission from IBR.