IBM xSeries 206m, Problem Determination And Service Manual

Page: 82 / 144

2. When the prompt
Press F1 for Configuration/Setup
appears, press F1. If you
have set both a power-on password and an administrator password, you must
type the administrator password to view the error logs.
3. Use one of the following procedures:
v
To clear the BMC system event log, select Advanced Setup --> Baseboard
Management Controller (BMC) Setting . Set Clear System Event Log to
Enabled ; then, press Esc.
v
To clear the combined system event/error log, select Error logs , and then
select System Event/Error Log . When any log entry is displayed, press
Enter ( Clear event/error logs is highlighted on each entry page).
Note: The POST error log is automatically cleared with each system restart.
POST error codes
The following table describes the POST error codes and suggested actions to
correct the detected problems.
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, Type 8849 and Type 8491 server,” on page 19 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
062 Three consecutive boot failures using the
default configuration.
1. Run the Configuration/Setup Utility program, save
the configuration, and restart the server.
2. Update the system firmware to the latest level
(see “Updating the firmware” on page 11).
3. Reseat the following components, one at a time,
in the order shown, restarting the server each
time:
a. Battery
b. (Trained service technician only)
Microprocessor
c. (Trained service technician only) System
board
4. Replace the components listed in step 3, one at a
time, in the order shown, restarting the server
each time.
101, 102 System and processor error.
1. (Trained service technician only) Reseat the
system board.
2. (Trained service technician only) Replace the
system board.
106 System and processor error.
1. (Trained service technician only) Reseat the
system board.
2. (Trained service technician only) Replace the
system board.
66
IBM xSeries 306m Types 8849 and 8491: Problem Determination and Service Guide