IBM TotalStorage SAN256N Director 2045-N16, Installation And Maintenance Manual, Page: 87 / 157

Chapter 4. Feature installation and configuration
67
Note: The pcAnywhere application finds all installed and functional modems attached
to the workstation. If an attached modem is not found, it will need to be
determined what the problem is prior to moving forward with the configuration.
1. From the main screen, right-click the Modem remote connection and select
Properties.
2. Check the appropriate modem from the device list. Select Low bandwidth (modem
connection) in the Optimized for listing. Select the Settings tab.
3. From Host startup, select Launch with Windows and Run minimized. Click on the
Callers tab.
4. Define a caller by selecting the New Item icon. It is the left most icon below the Caller
List.
5. Input the Login name of admin and the customer specific password. Click OK.
The user name of admin is now listed in the caller list.
6. Click on the Security Options tab.
7. Select pcAnywhere encoding in the Encryption Level pull down menu. Select the
Apply and OK buttons to save the configuration.
Start a dial-up host session
Use the following procedure to start a dial-up (modem) session to the host (local)
workstation.
1. From the main screen, right-click the Modem host connection and select Start Host.
2. The left most icon shows where pcAnywhere is waiting for a connection. If the
workstation has been rebooted prior to starting a communications session, this icon
should be displayed since the Launch with Windows option was selected.
Configure a dial-up remote connection
Use the following procedure to configure dial-up (modem) connectivity to the remote
workstation.
Note: The pcAnywhere application finds all installed and functional modems attached
to the workstation. If an attached modem is not found, it will need to be
determined what the problem is prior to moving forward with the configuration.
1. From the main screen, right-click the Modem remote connection and select
Properties.
2. Check the appropriate modem from the device list. Select Remote Control from the
Start mode listing. Select the Settings tab.
3. Enter the phone number of the host PC and the correct country. Entering the login
information is optional. If it is not defined in the modem profile, the host PC will
prompt the user at the time of connection. Select the Security Options tab.
4. Select pcAnywhere encoding in the Encryption Level pull down menu. Select the
Apply and OK buttons to save the configuration.