IBM TotalStorage SAN256N Director 2045-N16, Installation And Maintenance Manual, Page: 132 / 157

SAN256N Director 2045-N16
112
TCM/TFIO/TSW board boot blink codes
31 I2C Error I2C error detected at board bringup; prevents memory
configuation
32 CPLD Error: Invalid Board
Type Board type invalid (0xff); caused by unseated board
33 CPLD Error: Invalid Geo
Slot Address Slot address invalid (0xff); caused by unseated board
34 RAM Post Diagnostic Test
Failed Preliminary RAM test failed
41 Comprehensive DRAM Test (3.5 minutes)
42 Comprehensive Boot Flash Checksum
43 Comprehensive FCC1 Eth PHY Loopback
44 Comprehensive FCC2 Eth PHY Loopback
51 Boot Full DRAM Test
52 Boot Checksum Test (Board Boot) 52
Table 14. TCM/TFIO/TSW board boot blink codes
Heartbeat LED
Blink Count
Pattern
Error Code Description
Note: The blink codes are in decimal format with a 3 second pause between code restarts. Using 127 as
an example, the blink pattern would be: 1 blink, pause, 2 blinks, pause, 7 blinks, long pause,
repeat.
111 BCUB Boot - Inti UPM B Settings
111 CCUB Run Comprehensive Test - Init UPM B Settings
112 BCPF Boot - Program TCM FPGA
112 CCPF Run Comprehensive Test to Program TCM FPGA
113 BCRF Boot - Init TCM FPGA
113 CCRF Run Comprehensive Test - Init TCM FPGA
114 BRUN Boot - Jump to Application
115 BTPF Boot - Program TFIO FPGA
115 CTPF Run Comprehensive - Program TFIO FPGA
116 BTIF Boot - Init TFIO FPGA
116 CTIF Run Comprehensive - Init TFIO FPGA
116 Run Comprehensive - Init TFIO ASIC
117 BBTF Run TFIO Cyclone Autoboot
Table 13. TCM/TFIO/TSW PROM boot blink codes (Continued)
Heartbeat
LED Blink
Count Pattern
Error Code Description