Replacing the battery
IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
CAUTION: When replacing the battery, use only IBM Part Number 10L6432 or
an equivalent type battery recommended by the manufacturer. If
your system has a module containing a lithium battery, replace it
only with the same module type made by the same manufacturer.
The battery contains lithium and can explode if not properly used,
handled, or disposed of.
Do not:
v
Throw or immerse into water
v
Heat to more than 100°C (212°F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note:
In the U.S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
Batteries and accumulators that contain heavy metals must not be disposed of with
normal domestic waste. They will be taken back free of charge by the manufacturer,
distributor, or representative, to be recycled or disposed of in a proper manner.
Note:
Before you begin be sure to read any special handling and installation
instructions supplied with the replacement battery.
Note:
After you replace the battery, you must reconfigure your engine and reset the
system date and time.
To replace the battery:
1. Review any special handling and installation instructions supplied with the
replacement battery.
2. Power-off the engine and peripheral devices and disconnect all external cables
and power cords; then, remove the engine cover.
3. Remove the battery:
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery from its socket. The spring
mechanism behind the battery will push the battery out toward you as you
slide it from the socket.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
28
IBM NAS 300 Service Guide
Summary of Contents for TotalStorage NAS 300
