IBM TotalStorage L10, Cli Reference Manual

Page: 54 / 96

2006 Model L10 Storage Switch
42
Setting the Bad Zone Recovery Reset Hold Time
(root/config/zone/bzht)
The Bad Zone Recovery Hold Time is the amount of time that the switch keeps the ports
in bypass mode before attempting to re-insert the ports into the zone. This setting is
measured in milliseconds (.001 seconds). The default Reset Hold Time setting is 100.
To change the time interval:
1. From the Zoning configuration menu (root/config/zone), type
bzht
and press E
NTER
.
The current time interval appears in brackets before the command prompt.
2. Type the new time interval and press E
NTER
. The valid range is 10 to 1000
milliseconds (mSec).
Setting the Bad Zone Recovery Delay Time (root/config/zone/bzdt)
The Bad Zone Recovery Delay Time is the amount of time that the switch waits after a
zone goes down before attempting to recover the zone. This setting is measured in
seconds. The default Delay Time setting is 5.
To change the time interval:
1. From the Zoning configuration menu (root/config/zone), type
bzdt
and press E
NTER
.
The current time interval appears in brackets before the command prompt.
2. Type the new time interval and press E
NTER
. The valid range is 1 to 32 seconds.
Adding a port member to a zone (root/config/zone/addprt)
This command adds a port to a zone. Each port may be added to zones 1-11. Zone 0 is
the default zone and is not user definable. Zone 0 contains all ports not included in
zones 1-11.
When displaying the zone information and zoning is not active, Zone 0 displays all ports.
If zoning is active, Zone 0 only shows the ports currently active in Zone 0.
Note: Changes to zone configurations require that zoning be active. See “Activating
zoning (root/config/zone/act)” on page 43.
To add a port to a zone:
From the Zoning configuration menu (root/config/zone), type
addprt <zone number>
<port numbers>
and press E
NTER
.
Note: To add multiple port members, use spaces or commas between port members.
For example: If Zone 1 will consist of an HBA (port 3) and two targets (ports 5 and 7)
then to create Zone 1, type
addprt 1 3,5,7
and press E
NTER
.