IBM SAN768B-2, User Manual

Page: 43 / 228

Note: For the SSR branch and territory, the United States cannot order the lift tool
or 24–inch load plate through the parts order system. UPS Logistics are used to
ship and return the lift tool and 24–inch load plate.
Use the following part number when you order:
v
Lift tool: PN 09P2481 (order includes 24–inch load plate: PN 11P4369)
Attention: When you order the lift tool, you will receive an 18–inch load plate
and a 24-inch load plate. Do not use the 18–inch load plate. You must use the
24–inch load plate when you install the SAN768B-2 to be able to safely install this
product. The 24-inch load plate includes a platform with a middle section that can
slide out to extend across the gap between the lift tool and the mounting position
inside the C36 cabinet.
You must provide the following information when you order the lift tool. This
information is necessary to ensure that the lift tool is delivered when you need it.
Failure to provide this information might delay the completion of the order request
and the shipping request. It might also result in a time and date to return the tool
that is different from what you need.
v
Phone number and customer contact
v Account code: 98577
v
Time and date of delivery
v
Accurate destination address with ZIP code
v
Time and date of return pickup
You must return the lift tool at the time that was scheduled with UPS Logistics. If
you need to change the scheduled return time or date, contact UPS Logistics.
You are responsible for ensuring that all of the paperwork and components are
packed and restored in the arbocrate (shipping container) of the lift tool. Ensure
that the lift tool is functioning properly before you release the tool to UPS Logistics
for return. You are accountable for the lift tool until UPS Logistics picks up the lift
tool for return delivery to their parts storage facility.
Contact your branch office tools coordinator or your region specialist if you have
any questions or concerns.
Installation guidelines
Follow these general installation guidelines:
1. Provide a space that is 14 rack units (14U) high, 61.29 cm (24.09 in.) deep, and
43.74 cm (17.22 in.). 1U is equal to 4.45 cm (1.75 in.).
2. Plan to install the SAN768B-2 with the non-port side facing the air-intake aisle.
The SAN768B-2 can be installed facing either direction, if serviceability and
cooling requirements are met.
3. Plan for cable management before installing the chassis. See “Managing cables”
on page 46.
Cables can be managed in a variety of ways, such as by routing cables below
the chassis, to either side of the chassis, through cable channels on the sides of
the cabinet, or by using patch panels.
4. Ensure that dedicated electrical branch circuits with the following
characteristics are available:
Chapter 2. Installing a SAN768B-2 in a cabinet
15