IBM SAN192C-6, Installation, Service And User Manual

Page: 73 / 160

Chapter 3. Installing the IBM c-type SAN Device
This chapter describes how to install the IBM c-type SAN Device chassis and its
components, and includes the following information:
v “Attaching Bottom-Support Rails to a Four-Post Rack” on page 53
v “Attaching Bottom-Support Rails to a Four-Post Rack” on page 53
v “Attaching Bottom-Support Rails to a Two-Post Rack for the SAN192C-6
Director” on page 52
v “Installing the SAN384C-6 or SAN768C-6 Device on a Four-Post Rack or
Cabinet” on page 62
v “System Grounding” on page 71
v “Installing, Removing and Verifying Field Replaceable Units” on page 75
v “Installing and Removing a Power Supply” on page 81
v “Installing and Removing Fan Modules” on page 86
Precautions for Installation
Note: Before you install, operate, or service the system, read the IBM Systems
Safety Notices for important safety information.
Note: IMPORTANT SAFETY INSTRUCTIONS
This warning symbol indicates danger. You are in a situation that could cause
physical injury. Before you work on any equipment, be aware of the hazards
involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each
warning to locate its translation in the translated safety warnings that accompanied
this device.
SAVE THESE INSTRUCTIONS
Note: This unit is intended for installation in restricted access areas. A restricted
access area can be accessed only through the use of a special tool, lock and key, or
other means of security.
Note: Only trained and qualified personnel should be allowed to install, replace,
or service this equipment.
Note: A readily accessible two-poled disconnect device must be incorporated in
the fixed wiring.
Preparing for Installation
This section provides the following topics:
v “Unpacking and Inspecting the Switch” on page 50
v
“Required Equipment” on page 51
v “Installation Guidelines” on page 51
© Copyright IBM Corp. 2018
49