IBM SAN192C-6, Installation, Service And User Manual, Page: 83 / 160

a. Push and hold the release handle on the power supply to the left.
b.
Pull the power supply about two inches (about 5 cm) out of the chassis.
c. Place one hand under the power supply to support its weight and pull the
power supply out of the chassis.
d. Place the power supply on an antistatic surface.
To remove a fan module, follow these steps:
a. Unscrew the four captive screws on the front of the fan module (one
captive screw in each corner of the front of the fan module).
b. Hold both handles on the fan module with both of your hands and pull
the fan module out of the chassis.
c. Place the fan module on an antistatic surface.
To remove a fabric module, follow these steps:
Note:
Before you can remove a fabric module, you must remove the fan
module that is installed in front of it.
a. Press the lever eject button found in the middle of the front of the module.
b. Rotate both of the levers away from the fabric module.
c. When the other end of each lever is no longer holding onto the chassis,
pull the two levers to slide the module a couple inches out of the chassis.
d. Rotate the two levers back to the fabric module. Each lever will click when
locked in place.
e. Place one hand on the front of the module and place your other hand
under the module to support its weight.
f. Slide the module out of the chassis and place the module on an antistatic
surface.
2. Load the chassis onto a mechanical lift or floor jack as follows:
a. Position the mechanical lift next to the shipping pallet that holds the
chassis.
b. Elevate the lift platform to the level of the bottom of the chassis (or no
more than 1/4 inch [0.635 cm] below the bottom of the chassis).
c. Use two persons to slide the chassis fully onto the lift so that the side of
the chassis touches or is close to the vertical rails on the lift. Make sure
that the front and rear of the chassis are unobstructed so you can easily
push the chassis into the rack.
Note:
To prevent personal injury or damage to the chassis, never attempt to
lift or tilt the chassis using the handles on modules (such as power supplies,
fans, or cards); these types of handles are not designed to support the weight
of the unit.
CAUTION:
To lift the chassis, use a mechanical lift. Do not use the handles on the side
of the chassis (the handles are not rated for lifting over 200 pounds [91 kg]).
Use the side handles for only repositioning the chassis after it is already on
the mechanical lift or in the rack or cabinet.
3. Use the mechanical lift to move and align the rear of the chassis to the front
of the rack or cabinet. Make sure that the bottom of the chassis is elevated to
the height of the bottom-support rails or no more than 1/4 inch (0.6 cm)
above the rails.
4. Push the chassis halfway onto the rack or cabinet.
Use two persons to push the chassis onto the bottom-support rails. Push the
lower half of the front side of the chassis so that the back side enters the rack
Chapter 3. Installing the IBM c-type SAN Device
59