IBM SAN192C-6, Installation, Service And User Manual

Page: 39 / 160

Table 3. IBM Supervisor-1E Module LEDs (continued)
LED Status Description
Active Green The supervisor is operational
and in HA active state.
Amber The supervisor module is in
HA standby state.
Power Management Green There is sufficient power
available for all installed
modules.
Amber There is insufficient power
for all installed modules.
MGMT Ethernet Green The mgmt0 interface is
administratively active and
the supervisor is in HA
active state.
Amber The mgmt0 interface is
administratively active and
the supervisor is in the HA
standby state.
Flashing amber The management port link is
bad and has been disabled
due to a hardware failure.
Off The mgmt0 interface is
uninitialized. No signal is
detected.
ACT Flashing Green Frames are being transmitted
or received by the interface.
Off There is no activity on the
interface.
Link Green The management port link is
operational.
Off No link signal received.
LOG FLASH Green The log flash CompactFlash
or USB disk is being
accessed. Do not remove the
media until the LED is off..
Off The expansion flash
CompactFlash or USB disk is
not being accessed. You can
remove the media while this
LED is off.
Slot0 Green The log flash CompactFlash
or USB disk is being
accessed. Do not remove the
media until the LED is off.
Off The expansion flash
CompactFlash or USB disk is
not being accessed. You can
remove the media while this
LED is off.
Chapter 1. Introducing the IBM c-type SAN Directors
15