The second line of the front-panel display shows the current fibre-channel
speed setting of the node. Press the up or down button until
1 Gbps
is
displayed and then press the select button. This changes the fibre-channel
speed for all ports on this node to 1 Gbps.
18.
If you want to select a language other than English, perform the following
steps:
a.
Press the up or down button until
Select Language?
is displayed.
b.
Press the select button.
c.
Press the left or right button until the required language is displayed.
d.
Press the select button.
If the battery needed to be charged, the
Charging
or
Recovering
message is
replaced by the
Cluster:
message when the battery is fully charged. The
progress bar no longer displays. The installation of the SAN Volume
Controller hardware is now complete. No software installation is required.
Continue with the instructions in the
IBM System Storage SAN Volume
Controller Software Installation and Configuration Guide
to create, if necessary, a
new SAN Volume Controller cluster and to add the nodes into a SAN Volume
Controller cluster.
Chapter 4. Installing the SAN Volume Controller 2145-8F4 or the SAN Volume Controller 2145-8F2 hardware
53
