Installing the support rails for the 2145 UPS-1U
You must install the support rails in the rack before installing the 2145 UPS-1U.
Complete the following prerequisites before installing the support rails:
1.
Use the customer’s hardware-location chart to determine where in the rack that
the 2145 UPS-1U is to be installed.
2.
At the back of the rack, observe the Electronic Industries Alliance (EIA)
positions and determine where you are going to install the 2145 UPS-1U.
Because of its weight, position the 2145 UPS-1U where it is easy to handle in
one of the lower positions in the rack.
Perform the following steps to install the support rails for the 2145 UPS-1U:
1.
Open the top of the 2145 UPS-1U shipping carton. Grip the flaps on either side
of the 2145 UPS-1U.
2.
Lift the 2145 UPS-1U clear of the shipping carton and place it on a flat, stable
surface with the front facing you.
3.
Attach the long side of a mounting bracket
1
to each side of the 2145 UPS-1U
using four M3
×
6 screws
2
for each bracket, as shown in Figure 27.
4.
Loosen the assembly wing nuts (
1
in Figure 28) on both rail assemblies and
adjust the rail size to the depth of your rack. After you adjust the depth,
tighten the assembly wing nuts as much as possible while still allowing some
movement.
1
Assembly wing nuts
1
2
svc00004
Figure 27. Installing the support rails for a 2145 UPS-1U into the rack
Front
Rear
svc00033
2
1
Figure 28. Adjusting the rail depth on the 2145 UPS-1U
36
IBM System Storage SAN Volume Controller: Models 2145-8F2 and 2145-8F4 Hardware Installation Guide
1
1
1
1
