Installing the SAN Volume Controller 2145-8F2 or the SAN Volume
Controller 2145-8F4
There are several steps that you must perform to install the SAN Volume
Controller 2145-8F2 or the SAN Volume Controller 2145-8F4 nodes.
Installing the SAN Volume Controller 2145-8F2 or the SAN Volume Controller
2145-8F4 consists of the following tasks:
1.
Installing the support rails in the rack cabinet.
2.
Installing the SAN Volume Controller 2145-8F2 or the SAN Volume Controller
2145-8F4.
3.
Connecting the SAN Volume Controller 2145-8F2 or the SAN Volume Controller
2145-8F4 to the uninterruptible power supply.
4.
Installing the cable retention bracket on the SAN Volume Controller 2145-8F4.
Installing the support rails for the SAN Volume Controller
2145-8F4 or the SAN Volume Controller 2145-8F2
You must install the support rails that hold the SAN Volume Controller 2145-8F4
or the SAN Volume Controller 2145-8F2.
When you are ready to install the support rails, use the customer’s
hardware-location chart and the Electronic Industries Alliance (EIA) positions on
the rack to determine where in the rack that the SAN Volume Controller node is to
be installed.
Perform the following steps to install the support rails:
1.
Check the labels on the support rails. Each rail has a label that indicates which
is the front end of the rail and whether the rail is for the left or right side of
the rack. Perform this procedure for both rails.
2.
Put your index finger against the side of the latch-lever,
1
in Figure 39, and
put your thumb against the front of the latch-lock
2
.
1
Latch-lever
1
2
Figure 39. Retracting the latch-lock carrier
Chapter 4. Installing the SAN Volume Controller 2145-8F4 or the SAN Volume Controller 2145-8F2 hardware
43
