IBM S822LC, Installing The System And Ordered Parts

Page: 96 / 140

Table 19. POST conditions and results
Green LED Yellow LED State
Off Off Wake-up failure of the adapter board
Off On POST failure of the adapter board
Off Slow flash Wake-up failure monitor
Off Fast flash Failure in post
Off Flashing Postprocessing in progress
On Off Failure while functioning
On On Failure while functioning
Slow flash Off Normal, link down
Slow flash On Not defined
Slow flash Slow flash Offline for download
Slow flash Fast flash Restricted offline mode, waiting for
restart
Slow flash Flashing Restricted offline mode, test active
Fast flash Off Debug monitor in restricted mode
Fast flash On Not defined
Fast flash Slow flash Debug monitor in test fixture mode
Fast flash Fast flash Debug monitor in remote debug
mode
Fast flash Flashing Not defined
PCIe3 4-Port (10 Gb + 1 GbE) SR+RJ45 Adapter (FC EN0S; CCIN 2CC3)
Learn about the specifications and operating system requirements for the feature code (FC) EN0S adapter.
Overview
The PCIe3 4-Port (10 Gb + 1 GbE) SR+RJ45 Adapter is a PCI Express (PCIe) generation 3 (Gen3) x8, short
form-factor, low-profile capable, full-height adapter. The adapter provides two 10 Gb SR optical ports and
two 1 Gb RJ45 ports. This adapter provides a PCIe 3.0 host bus interface. The adapter supports the
Ethernet network interface controller (NIC) function. The adapter is a high-performance adapter that
consolidates traffic for networking. The link aggregation and failover features of the adapter make it
suitable for critical network applications that require redundancy and high availability.
The four-port adapter provides two 10 Gb small form-factor pluggable (SFP+) optical SR transceiver ports
and two 1 Gb RJ45 Ethernet ports. The two 10 Gb SR ports have little connector (LC) duplex-type
connectors. The optical transceiver uses shortwave laser optics and is attached with MMF-850nm fiber
cabling with LC connectors. See “Cables” on page 83 for more information about the optical cables. Each
10 Gb port provides Ethernet connectivity with a nominal data rate of 10 Gbps (gigabits per second).
Figure 61 on page 82 shows the FC EN0S adapter.
Each of the 1 Gb RJ45 port provides Ethernet connectivity at a data rate of 1 Gbps. Each of the 1 Gb ports
is connected with a 4-pair, CAT-5 unshielded twisted pair (UTP) cable or with a cable of higher
specification, and is supported for distances of up to 100 meters. In addition to 1 Gb (1000 Mb) networks,
100 Mb networks are also supported.
The adapter provides the following features:
v The adapter is a PCIe3 NIC network convergence adapter.
v The 10 Gb SR ports can function in the NIC mode.
80
Installing the System and Ordered Parts for the 8335-GCA or 8335-GTA