Note:
Cable the system and set up a console, interface, or terminal. To cable the system, see “Cabling the
server and setting up the console” on page 19.
To connect power cables to the system, complete the following steps:
1.
While facing the rear of the system unit, route the system power cord through the cable retention
bracket.
Note:
You might need to pull the power supply out slightly to route the cable though the retention
bracket. After you route the cable through the retention bracket, reseat the power supply.
2.
Plug the power cord into the power supply.
Note:
This system is equipped with two power supplies. If you want to configure the system with
redundant power supplies, you must connect each power cable to its own power source.
3.
Plug the system power cords and the power cords for any other attached devices into the alternating
current (ac) power source.
Note:
Confirm that the system is in standby mode. The green power status indicator on the front
control panel is flashing slowly, and the dc out indicator lights on the power supplies are flashing. If
none of the indicators are flashing, check the power cord connections. For detailed information, see
“Common system attention LEDs and system reference codes” on page 40.
26
Power Systems: Installing the IBM Power 750 (8408-E8D) and IBM PowerLinux 7R4 (8248-L4T)
Summary of Contents for Power 750 Express 8408-E8D
