IBM Nortel Networks L2/3, Manual

Page: 22 / 190

8
Nortel Networks L2/3 Ethernet Switch Module for IBM
Eserver
BladeCenter
2.2.2 Management Module Ethernet
Figure 2-4 illustrates the Management Module Ethernet interface. The switch modules are
configured by the active Management Module through the use of a 100 Mb Ethernet interface.
Each Management Module has four 100 Mb Ethernet interfaces, one for each switch module.
Each switch module has two 100 Mb Ethernet interfaces, one for each Management Module.
The following list clarifies the routing:
򐂰 Management Module 1 Ethernet 1
→
Switch Module 1 Ethernet MGT1
򐂰 Management Module 1 Ethernet 2
→
Switch Module 2 Ethernet MGT1
򐂰 Management Module 1 Ethernet 3
→
Expansion Switch Module 3 Ethernet MGT1
򐂰 Management Module 1 Ethernet 4
→
Expansion Switch Module 4 Ethernet MGT1
򐂰 Management Module 2 Ethernet 1
→
Switch Module 1 Ethernet MGT2
򐂰 Management Module 2 Ethernet 2
→
Switch Module 2 Ethernet MGT2
򐂰 Management Module 2 Ethernet 3
→
Expansion Switch Module 3 Ethernet MGT2
򐂰 Management Module 2 Ethernet 4
→
Expansion Switch Module 4 Ethernet MGT2
Figure 2-4 Management Module Ethernet interface
The redundant paths of the Management Module Ethernet interface are run from
Management Module 2.
Note: On the Nortel Networks L2/3 GbESM, the management Ethernet ports on the switch
are referred to as MGT1 and MGT2. For more information beyond this generic illustration,
see Chapter 4, “Nortel Networks Layer 2/3 GbE Switch Module architecture” on page 21.
IBM
^
BladeCenter™ -
Management Module Ethernet Interface
Management
Module 1
Management
Module 2
CPU
Blade
1
CPU
Blade
2
CPU
Blade
14
Blower
Blower
Power
Module
Power
Module
Power
Module
Power
Module
Front
Panel/Media
Tray
Switch
Module
Switch
Module
Switch
Module
Switch
Module