IBM IntelliStation M Pro 6225, Hardware Maintenance Manual And Troubleshooting Manual

Page: 95 / 176

No-beep symptoms
No-beep symptom FRU/action
No beep occurs during POST. System board
No beep, no video, and the
system attention LED (if
present) is off.
System board
No beep, no video, and the
system attention LED (if
supported) is on.
See “Undetermined problems” on page 102
BIST failed. Microprocessor
Diagnostic error codes
Note: In the following error codes, if XXX is 000 , 195 , or 197 , do not replace a
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
Error code/symptom FRU/action
001-XXX-000
(Failed core tests)
System board
001-XXX-001
(Failed core tests)
System board
001-250-000
(Failed system board ECC)
System board
001-250-001
(Failed system board ECC)
System board
005-XXX-000
(Failed video test)
1. Video adapter (if installed)
2. System board
011-XXX-000
(Failed COM1 serial port test)
1. Check loopback plug connected to externalized serial port.
2. System board.
011-XXX-001
(Failed COM2 serial port test)
1. Check loopback plug connected to externalized serial port.
2. System board.
014-XXX-000
(Failed parallel port test)
System board
015-XXX-001
(USB interface not found, board damaged)
System board
015-XXX-198
(USB device connected during USB test.)
1. Remove USB devices from USB1, USB2, USB3, USB4, USB5,
and USB6; then, run the USB interface test again.
2. System board.
Chapter 6. Symptom-to-FRU index
85