IBM IntelliStation E Pro 6836, User Manual

Page: 83 / 156

10. If you have another drive to install or remove, do so now.
11.
Connect the power cable from the power supply into the back of the drive.
The connectors are keyed and can be inserted only one way.
Attention: To prevent damaging your computer, hold onto the drive cage
when you release it from the chassis.
12. Lift up on the drive cage and rotate the release latch to the unlocked position.
Attention: Ensure that all cables have been moved from under the drive
cage so that the power or signal cables are not damaged.
13. Pivot the drive cage back into the computer and press down on the cage until
it locks in place.
14.
If you have other options to install or remove, do so now.
15. Reinstall the cover (see “Installing the cover” on page 69 for details).
16.
Reconnect the external cables and power cords; then, turn on the attached
devices and the computer.
Installing memory modules
Adding memory to your computer is an easy way to make programs run faster.
You can increase the amount of memory in your computer by installing options
called memory modules. Your computer uses a noninterleaved memory
configuration.
Your computer comes with a DIMM installed on the system board in DIMM
connector 1.
Notes:
1.
When installing additional memory modules, install the second memory
module in DIMM connector 2, and the third in DIMM connector 3. (See the
illustration in this section for memory connector locations.)
2. Your IntelliStation E Pro computer supports 64 MB, 128 MB, 256 MB, and 512
MB DIMMs. Your computer supports a minimum of 64 MB and a maximum
of 1.5 GB of system memory. Go to http://www.ibm.com/pc/support for a list
of memory modules for use with your computer.
3. The illustrations in this document might differ slightly from your hardware.
DIMM connector 1
DIMM connector 2
DIMM connector 3
Retaining clip
Complete the following steps to install a DIMM.
Chapter 5. Installing options
67